Cooper Menvier 9752, Инструкция по установке и программированию

Страница: 22 / 96

16 496792
3. Installation
Cooper Security recommend that you mount the keypad using No 8 or 6
screws (M4/M3.5) as follows:
1. Select which cable entry you are going to use and break out the appro-
priate plastic sections.
2. Hold the backplate in place against the wall and mark the position of the
centre hole in the adjustable cam (see Figure 7).
3. Drill and plug the hole, and screw the backplate to the wall through the
adjustable cam. Do
not tighten the screw completely home.
4. Make sure the backplate is level and mark, drill and plug at least two
other fixing holes. Screw the backplate to the wall through the fixing
holes.
5. Cut the plastic webs connecting the cam to the remainder of the base
plate.
Note: If you do not cut the webs then the tamper switch will not operate if the
complete keypad is forced off the wall.
6. Mount the front of the keypad (containing the keypad pcb) onto the
backplate and make sure that the tamper switch operates.
7. If the tamper switch does not operate then rotate the cam until the
tamper switch operates correctly when the front of the keypad is
mounted on the backplate.
Wiring the Control Unit
Cable Entries
The control unit case back provides several cable entries. The back is
designed to stand away from the wall to leave space for cables.
Mains Connection
The control unit must be permanently connected to a 3A fused spur outlet
fitted with a readily accessible disconnect device. Connect the mains supply
to the control unit using the 3-way terminal block located in the control unit
back. Secure the mains cable to the case anchor point using the cable tie
provided. Note that the control unit has a T-250mA internal mains fuse. All
electrical connections should be carried out by a qualified electrician and
must comply with the current IEEE Wiring Regulations - Standard Circuit
Arrangement.