Cooper Menvier 9752, Инструкция по установке и программированию

Страница: 37 / 96

496792 31
3. Installation
Initial Start Up
Before applying power to the control unit, ensure that:
• All remote keypads and expanders have been addressed and con-
nected.
• All external and internal sounder are connected.
• All wired zone circuits are connected.
• All wireless zones have been learned to their expanders.
Then:
1. Connect the battery to the control unit PCB.
2. Briefly short the kick start pins together (they are located above battery
fuse, see Figures 3 or 4).
The green power LED on the keypad flashes and the internal sounder
may sound. Ignore any display at this stage.
3. Key-in the factory default user access code: 1234.
The internal sounder stops. Ignore any other display at this stage.
4. Please fit the case lid before applying mains power (this also defeats the
tamper switch).
5. Apply mains power.
The Power LED on the keypad glows steadily.
6. Key-in 0 followed by the factory default engineer access code: 7890.
(You do not have to remove the control unit lid.)
The display shows:
Installer Mode
You are now in programming mode.
Carry on to Chapter 4 in order to program the system.