Cooper Menvier 9752, Инструкция по установке и программированию

Страница: 76 / 96

4. Programming
70 496792
Communicator Telephone Numbers (Command 115/116)
Use this Command to store the telephone numbers that the communicator
will use to report alarms. The system will accept one telephone number if you
choose Single call mode in Command 101, or two telephone numbers if you
select Alternate or Dual call mode.
The system can store telephone numbers up to 31 digits long.
You can use the A key to insert a pause (four seconds).
To enter a number:
1. Enter programming mode (if you are not already there).
2. Key in 115 (or 116)
Y
at the keypad.
The display shows (for example):
115:Tel No 1_
3. Press
Y
.
4. Key in the digits of the number. If necessary press D to move the cursor
to the left to edit or delete the number. Press C to move the cursor to
the right.
The display shows (for example):
115: 1234_
5. Press
Y
.
The keypad gives a double beep and the system stores the number.
Account Number (Command 117)
With SIA Format the system can report alarms using a six digit account code.
Use leading zeros to pad the account code to the correct length if necessary,
for example account 1234 would be 001234.
To enter an account code:
1. Enter programming mode (if you are not already there).
2. Key in 117
Y
at the keypad.
The display shows: 117: Account No
3. Press
Y
.
The display shows (for example): 117: 000000
4. Key in the digits of the account code. (If the account code is correct
simply press
Y
.) Press C between each digit to move the cursor to the
right. Press D to move the cursor to the left to correct any mistakes.
The display shows (for example):
117: 123456
5. Press
Y
to store the account code.
Note: Some European countries use letters in the account code. The control unit can
accept any of the letters B, C, D, E and F as part of the account code. To enter
a letter at step 4 press 2 or 3 repeatedly until the letter you require appears on
the display (see “Zone Programming - Zone Names”).