September 2011
21
V1.44
Copyright © 2011 Adept Systems, Inc. and Control Network Solutions Ltd All Rights Reserved.
WiFi, and web parameters is in effect.
2.3.0.1. Basic Procedure
The basic procedure is to first reboot the device and then while its booting up press and hold
one of the service buttons.
To reboot the device, either press and release the Reset button or power cycle the eNodeIV
device. If powering down or resetting the device after making any configuration changes,
please use the
Prepare to Power Down
button on the Router Setup page to ensure that a flash
write operation induced by the changes is not interrupted by the power down. Interrupting a
flash write could corrupt the flash and make the unit inoperable.
Once the router starts rebooting, on the Ethernet version, the yellow link and green traffic LEDs
will go on solid while it loads its firmware, on the WiFi version the yellow and green LEDs will go
off. This will take about 30 seconds. Firmware load is completed when the yellow light flashes
off and back on and the green light goes starts flashing. About 10 -15 seconds later the router
will read the service button state to determine if a reset to defaults is desired. Consequently,
one has about 10 seconds after the green light starts flashing to press and hold down one of the
two Service buttons and then continue holding until it reads the button state. At which time
one may release the Service button.
To restate:
1) Appropriately reboot the router.
2) Wait until the IP Link yellow light goes on and the IP Traffic green light starts flashing.
3) Hold down either the
Service App
or
Service Router
button until the
Tx, Rx
and
Srv
lights all
come on solid (about 10 - 15 seconds). These lights will stay on for 3 seconds then go off.
4) Once the
Tx
,
Rx
and
Srv
lights come on, release the service button. (If after holding down
the button for 20 seconds the
Tx
,
Rx
and
Srv
lights don't come on then try again from the start.)
What happens next depends on which of the service buttons was pressed.
If the
Service Router
button is pressed, the IP address, port and (when applicable) the WiFi SSID
will be reset to factory defaults.
5) After about another minute the router will go into reset. This is indicated by the yellow link
light and the green traffic light both going on solid for the Ethernet unit and both going off for
the WiFi unit. Another minute later the router will boot up with all the IP parameters set to
factory defaults.
If the
Service App
button is pressed, the web user, password, and web server port will be reset
to factory defaults.
6) The router will continue its boot-up with all the web parameters set to factory defaults.
If both the
Service Router
and
Service App
buttons are pressed then both the IP and web
