Continental Access SUPERTERM CIC1800, Инструкция по установке и обслуживанию, Страница: 78 / 92

SETTINGS
Superterm CIC1800 / CICP1400UL 78
Door Strike Jumper Setting
Door strike power may be either LOCAL or
REMOTE (see page 22).
Each of the Superterm's door strike relays requires
setting two associated jumpers.
The jumpers, labeled S3 through S18, are located
on the Superterm circuit board below the bank of
relays and between the relay fuses (see Figure 49).
NOTE: Use insulated needle-nose pliers when
working with jumpers.
Table 50 relates the door strike relays to the
appropriate jumper numbers.
Table 50 - Door Strike Relays and
Associated Jumpers
Door Strike Relay # Jumper Pair
1 S3 and S4
3 S5 and S6
5 S7 and S8
7 S9 and S 10
9 S 11 and S 12
11 S13 and S14
13 S15 and S16
15 S 17 and S 18
LOCAL Power Jumper Setting
Operating specific relays on LOCAL power
requires setting two associated jumpers to the
LOCAL position.
Verify that both jumpers for the associated relay
(see Table 50) contact the center post, pin 2, and
the right-hand post, pin 3 (see Figure 49, Detail A).
NOTE: The letters R and L on the jumper refer to
REMOTE and LOCAL. They DO NOT refer to
Right and Left.
REMOTE Power Jumper Setting
Operating specific relays on REMOTE power
requires setting two associated jumpers to the
REMOTE position.
Verify that both jumpers for the associated relay
(see Table 50) contact the center post, pin 2, and
the left-hand post, pin 1 (see Figure 49, Detail B).
NOTE: The letters R and L on the jumper refer to
REMOTE and LOCAL. They DO NOT refer to
Right and Left.