Contec FX-DS110-APE, Руководство пользователя, Страница: 21 / 132

Component Locations and Setting
FX-DS110-APE
10
DIP switches
These are used for settings such as the COM port mode, LED
display, wireless channel, and initializing the AP.
Table 2.6. DIP Switches
MODEM/ Specifies whether a modem or terminal is connected to the COM port.
TERMINAL The default factory setting is TERMINAL.
RSSI
POWER(back) WLINK(back)
Off Off ADHOC Mode
On Off
Infrastructure mode,
unit type AP
Off On
Infrastructure mode,
unit type station
CHANNEL 1 CHANNEL 2
OFF OFF
ON OFF
OFF ON
ON ON
5 INIT
4 CHANNEL2
operation/function
Used to initialize the AP.
Setting this switch ON causes the POWER, MGMT, WLINK, and WTX/WRX LEDs to start
blinking. If the switch is turned OFF while the LEDs are still blinking (within
approximately 3 seconds), all AP settings return to their factory defaults the next time the
unit is restarted.
Sets the channel.
You can change the channel setting to separate network groups.
The switch settings allow the network to be configured with up to four independent groups.
When setting via software, it is recommended that a separation of at least 5 channels is
maintained to prevent interference between adjacent groups (wireless stations).
Channel
Not used
ch1
ch6
The above settings can select ch1, 6 and 11.
Ch1 to ch11 or 13 can be set by software.
ch11
Item
2
1
CHANNEL1 3
Changes the LEDs on the front panel (MGMT, WLINK, and WTX/WRX) to display RSSI.
This can be used in cases such as when adjusting the orientation of the optional antenna
when using the unit for inter-building or similar communications.
Also changes the LEDs on the rear (POWER and WLINK) to display the mode.
Mode