A p p e n d i x l
D - 2
I n s t a l l i n g D r y A i r B l a n k e t ( O p t i o n )
1
Disconnect and lockout the main power supply, and the air supply from the
blender.
2
Bolt the inlet air adaptor to the bottom of the blender.
3
Organize the piping from the dryer to the blender.
4
Loosely make all connections between the blender and the dryer, making sure
to install the slide gates where necessary.
5
Tighten all connections.
6
Follow instructions in the blender user guide, and the dryer user guide for test-
ing the installation. Run the dryer and check for leaks.
Inlet air adaptor
Isolation valves
Содержание TrueBlend SB-4
