Comtech EF Data CDM-425, Инструкция по установке и эксплуатации

Страница: 604 / 744

CDM-425 Advanced Satellite Modem
Revision 0
Appendix F F–2 MN-CDM-425
Technology uses the term DoubleTalk, and Comtech EF Data refers to it as DoubleTalk Carrier-
in-Carrier (CnC)
1
.
CnC was first introduced in Comtech EF Data’s CDM-Qx Satellite Modem and, more recently, in
the CLO-10 Link Optimizer. The implementation of DoubleTalk Carrier-in-Carrier in the CDM-425
Advanced Satellite Modem has been further refined, and some of the limitations that existed in
the CDM-Qx implementation have been overcome.
This innovative technology provides a significant improvement in bandwidth and power utilization,
beyond what is possible with FEC and modulation alone, allowing users to achieve
unprecedented savings. When combined with advanced modulation and FEC, it allows for multi-
dimensional optimization:
•
Reduced operating expense (OPEX) – e.g., Occupied Bandwidth & Transponder Power;
•
Reduced capital expenditure (CAPEX) – e.g., Block Up Converter/High-Power Amplifier
(BUC/HPA) size and/or antenna size;
•
Increased throughput without using additional transponder resources;
•
Increased link availability (margin) without using additional transponder resources;
•
A combination of any of the above to meet different objectives.
Summary: When carriers share common bandwidth, up to 50% savings in transponder
utilization is possible.
F.1.2 Application Requirements
The following conditions are necessary in order to operate DoubleTalk Carrier-in-Carrier:
•
Link must be full duplex.
•
A CDM-425 Advanced Satellite Modem must be used at the end of the link where the
cancellation needs to take place.
•
he transponder is operated as Loopback. That is, each end of the link must be able to
see a copy of its own signal in the return (downlink) path from the satellite. The looped
back signal is then subtracted which leaves the signal from the distant end of the link.
DoubleTalk Carrier-in-Carrier cannot be used in spot beam systems.
•
The transponder needs to be “bent-pipe” – meaning no on-board processing,
demodulation, regeneration can be employed. Demodulation/remodulation does not
preserve the linear combination of the forward and return signals and the resulting
reconstituted waveform prevents recovery of the original constituent signals.
Figure F-1 shows a simplified conceptual block diagram of CnC processing. The two ends of the
link are denoted ‘
A’ and ‘ B’ and the uplink and downlink are shown.
1
DoubleTalk
®
is licensed from Raytheon Applied Signal Technology.
DoubleTalk
®
is a registered trademark of Raytheon Applied Signal Technology.
Carrier-in-Carrier
®
is a registered trademark of Comtech EF Data.