Comtech EF Data CDM-425, Инструкция по установке и эксплуатации

Страница: 502 / 744

CDM-425 Advanced Satellite Modem
Revision 0
ODU (Transceiver, BUC, LNB) Operation 10–12 MN-CDM-425
10.3.3.3.2 ODU: LNB:PwRef (Power Supply and Reference)
LNB control/monitor:
PSU-and-10MHz LO-freq PSUmonitor (

)
The modem can supply DC power to an LNB connected to the Type ‘N’ rear panel Rx connector.
It can also supply a 10 MHz reference for a phase-locked LNB. Use the
◄ ►
arrow keys to select
PSU-and-10MHz , LO-freq , or PSUmonitor , and then press ENTER .
10.3.3.3.2.1 ODU: LNB:PwRef

PSU-and-10MHz
LNB: Voltage=Off 10MHz:Off (Off,On)
Alarm limits, from 000 to 500 mA (

)
Use the
◄ ►
arrow keys to select Voltage , 10MHz , or Alarm Limits . Then, use the
▲▼ arrow
keys to change that setting:
Selection Setting
Voltage Select Off, 13V, or 18V
10MHz Set the 10MHz Reference as Off or On.
Alarm Limits
Use the◄ ►arrow keys to select a digit to edit, and then use the ▲▼ arrow keys to
change that digit. Valid range, in mA, is 000 to 500.
Press ENTER when done.
10.3.3.3.2.2 ODU: LNB:PwRef

LO-Freq (Local Oscillator Frequency)
LNB-LO: Frequency= 00000 MHz
Mix= High [-] (Hi,Lo) (

)
Use the
◄ ►
arrow keys to select the LNB-LO (Local Oscillator) Frequency for the
downconversion, or Mix to set the polarity for the downconversion mix in the LNB.
On the top line – To set the LNB-LO Frequency , use the
◄ ►
arrow keys to select a digit to
edit, and then use the
▲▼ arrow keys to change that digit. The valid LO range is 3000 to 65000
MHz. Entering a non-zero value for LNB LO causes the Rx-IF frequency menu to show LO and
Satellite frequencies (
satellite frequency = LO frequency
±
modem frequency
).
Press ENTER when done.