Comtech EF Data CDM-425, Инструкция по установке и эксплуатации

Страница: 503 / 744

CDM-425 Advanced Satellite Modem
Revision 0
ODU (Transceiver, BUC, LNB) Operation 10–13 MN-CDM-425
On the bottom line – To set the Mix polarity , use the
▲▼ arrow keys to set polarity as
Hi (to
indicate a high side, inverting mix) or Lo (to indicate a low side, non-inverting mix).
Press ENTER when done.
10.3.3.3.2.3 ODU: LNB:PwRef

PSUmonitor
LNB Power Supply [Off]:
0000mA, 00.0V
This read-only display shows the LNB power supply information. Press ENTER or CLEAR to
return to the previous menu.
10.3.3.3.3 ODU: FSK-control
Comtech EF Data ODUs (CSAT, KST, or LPOD ), when connected to a CDM-425 through
Frequency Shift Keying (FSK), can be remotely monitored and controlled by using the CDM-425
front panel, Web Server interface, or by using remote commands and queries through Serial or
Telnet Remote Product Management. In order to facilitate remote M&C, the ODU address is set
up as follows:
•
For Local-End ODUs:
o
Use the Modem’s RC A 1 for a Standalone Unit or the Online Unit in a
1:1 Redundancy System
o
Use the Modem’s RC A 2 for the Offline Unit in a 1:1 Redundancy
System
•
For Distant-End ODUs in an EDMAC setup:
•
Chapter 8. SERIAL-BASED REMOTE PRODUCT MANAGEMENT
•
Appendix H. EDMAC CHANNEL
o
Use the EDMAC Slave Address (ESA) Range +4 for Standalone Unit or the
Online Unit in a 1:1 Redundancy System;
o
Use the EDMAC Slave Address (ESA) Range +5 for the Offline Unit in a 1:1
Redundancy System.
The appearance of the ODU: FSK-control screen adjusts automatically to the mode of operation:
70/140 MHz or L-Band.
When the Tx frequency is 70/140 MHz – Communication with a Comtech EF Data CSAT or
KST transceiver is achieved using a low-speed, half-duplex FSK link over the Rx IF port, with a
carrier frequency around 2.7 MHz.
With FSK communication disabled , the ODU: FSK-control screen appears as shown here:
ODU Control: FSK=Off (Off,On)
ODU Type: C/KST (C/KST, 2CSATS) (

)