Comtech EF Data CDM-425, Инструкция по установке и эксплуатации

Страница: 150 / 744

CDM-425 Advanced Satellite Modem
Revision 0
Front Panel Operation 6–32 MN-CDM-425
6.2.1.5.2 CONFIG: Clocks

Rx Buffer/Clock
Clk=Rx-Sat (Rx-Sat,TxTerr,Int(SCT))
Buffer Size = 00016bytes(00002ms) Center
Use the
◄ ►
arrow keys to set the Rx Clock (top line) or the Buffer-Size (bottom line).
On the top line – To set the Rx Clock , use the
▲▼ arrow keys to select a parameter. Press
ENTER . Valid settings are:
Setting Function
Rx-Sat
Sets the Receive buffer clock source to the satellite clock (the receive buffer is bypassed).
Note: This will fix the buffer size to minimum.
Tx-Terr
In this timing mode, data is clocked out of the receive buffer using the external transmit clock.
Int(SCT)
Data is clocked out of the buffer using the same reference that drives the modem Internal(SCT).
Ins(ert)
Available only if Rx framing is D&I and Rx interface is G.703. Sets the buffer clock to the Insert
stream.
On the bottom line – To set the Buffer-Size , use the
◄ ►
arrow keys to select a digit, and then
use the
▲▼ arrow keys to change that digit. Press
ENTER .
Buffer Size indicates the size in bytes (and size in milliseconds) of the
Plesiochronous / Doppler Buffer. The minimum buffer size and step size
(increment) are usually the same, and are dictated by the following rules:
If Framing is D&I or D&I++: Otherwise:
If D&I Type is: Step Size (bytes) If Data Rate is: Step Size (bytes)
E1 D&I @ 1920kbps 1024 1544 kbps (T1) 1158
T1-D4 24 x n or 3ms 2048 kbps (E1) 1024
T1-ESF 48 x n or 6ms 6312 kbps (T2) 1578
E1 32 x n or 4ms 8448 kbps (E2) 528
Otherwise
2, with minimum size of 16
bytes