Digital fire detection control panel
LYON
FIRE PROTECTION MANUFACTURER
Ctra. de Molins de Rei a Rubí, Km. 8,4 - 08191 RUBÍ (Barcelona) ESPAÑA.
48
Tlf.: +34 935 862 690 - Fax:+34 936 999 261 - [email protected] -
www.cofem.com
Anomalies during start-up:
1.
In the event that during the start up the control panel finds a new loop or power controller,
the following message will appear. The address indicates the type of controller loop
controllers being from
1
to
5
and power controller 11.
F o u n d
n e w
c o n t r o l l e r b o a r d
W i t h
a d d r e s s :
0 X X
P r e s s
E N T E R
t o
c o n f i g u r e
P r e s s
E S C
t o
c o n t i n u e
2.
In the event that the control panel does not find a previously configured controller the
following message appears offering the possibility of deleting it from the configuration.
D o
n o t
f o u n d
t h e
c o n t r o l l e r
b o a r d
W i t h
a d d r e s s :
0 X X
P r e s s
E N T E R
t o
d e l e t e
P r e s s
E S C
t o
c o n t i n u e
3.
In the event that the control panel does not find any loop controller, that is to say, that none
have been configured, it does not detect a new one or no controller has been configured as 1,
the following will appear:
D o
n o t
e x i s t
l o o p
c o n t r o l l e r
P r e s s
E N T E R
t o
c o n t i n u e
4.
In the event of continuing from the previous message and of continuing without a loop
controller, we will have the two options that are seen in the following figure: to reinitiate the
control panel or to continue and to start up the control panel without a configured loop
controller:
C O M U N I C A T I O N
E R R O R
L O O P
C O N T R O L L E R :
0 X X
P r e s s
E N T E R
t o
c o n t i n u e
P r e s s
E S C
t o
r u n
5.
In the event that the power controller does not exist, that is to say, that is to say, that none
have been configured and it does not detect a new one, the following will appear:
D o
n o t
e x i s t
p o w e r
s u p p l y
c o n t r o l l e r
P r e s s
E N T E R
t o
c o n t i n u e
6.
Finally the possibility exists that the I2C memory fails, where all the control panel
information is kept. In this case, we have two options. The first is to reinitialise the control
panel configuration, restoring the factory default values (except element and relay labels).
The second is to cancel the re-initialisation of the configuration. If after having reinitialised
the control panel the “I2C Failure” message appears again, it means that this unit is not
working correctly.
F a u l t
I n
I 2 C m e m o r y
R e b o o t
t h e
c o n f i g u r a t i o n
P r e s s
E N T E R
t o
c o n t i n u e
P r e s s
E S C
t o
c a n c e l
