COBHAM Sea Tel 9711-56 IMA C Band, Руководство по установке

Страница: 64 / 234

Installation in 168” Radome Sea Tel 9711-56 IMA
5-10
EAR Controlled - ECCN EAR99
31. Continue caulking toward the next bracket, using wedges to keep the horizontal seam
open if necessary.
32. Repeat steps 49 & 50 until all four brackets have been removed and caulking of the
entire horizontal seam is completed.
33. Assure that all brackets &
wedges have been removed,
apply Loctite to and firmly
tighten all of the horizontal
seam bolts.
34. Clean excess caulking off as
shown in step 17 above.
35. Remove tape from the riser
panels and the bottom edges of
the lower panels.
36. Loosely assemble the 8 upper
panels using the hardware
provided. Do NOT tighten the
bolts at this time. Assure good
horizontal alignment of the
panels. Good alignment of the
bottom edge of the upper
panels is important for good
seal between the upper and
lower panels.
NOTE: The person who is working inside
installing hardware, applying Loctite,
tightening hardware and cleaning the
inner flanges will remain inside until the
cap and lifting brackets are installed.
37. To provide a clean caulked seam
all around the panels: apply
painters masking tape to the
outside perimeter of each of the
panels about ¼ “ from the top,
bottom, left and right edges at
each flange joint. The tape will
be removed just before the
radome caulking has had time
to set.