COBHAM Sea Tel 9711-56 IMA C Band, Руководство по установке

Страница: 50 / 234

Installation in 144” Radome Sea Tel 9711-56 IMA
4-26
EAR Controlled - ECCN EAR99
7. Connect the TXIF coaxial cable that runs between the above decks and below decks
equipment to the TX connector on the interconnect bracket inside the louvered panels of
the AZ Post.
8. Connect the RXIF coaxial cable that runs between the above decks and below decks
equipment to the RX connector on the interconnect bracket inside the louvered panels of
the AZ Post.
9. After the cables are routed as desired, tighten the strain reliefs to provide holding
compression on the cables.
10. Reinstall the AFT louvered panel to the AZ Post.
4.6.3. Remove stow Straps
Remove the stow straps from the pedestal and repackage them in the Antenna Stow Kit.
Provide this kit to the responsible person aboard the ship so it can be stored for future use.
4.6.4. ADE Final Checks
Remove all tools, parts and installation debris from inside the radome.
Remove all tools, parts and installation debris from the area around the outside of the radome.
4.7. Installing the Below Decks Equipment
Connect this equipment as shown in the System Block Diagram. Install the equipment in a standard 19 inch
equipment rack or other suitable location. Optional slide rails are available for the Sea Tel MXP.
4.7.1. General Cautions & Warnings
CAUTION - Electrical Shock Potentials exist on the Gyro Compass output lines.
Assure that the Gyro Compass output is turned OFF when handling and connecting
wiring to the MXP.
CAUTION - Allow only an authorized dealer to install or service the Sea Tel System
components. Unauthorized installation or service can be dangerous and may
invalidate the warranty.
4.7.2. Connecting the BDE AC Power Cables
Connect the AC Power cables that supply power to the Below Decks Equipment (MXP, Satellite
Modem, phone, fax, computer and all other equipment) to an outlet strip fed from a suitably rated
breaker or UPS.
4.7.3. Media Xchange Point™ (MXP) Connections
4.7.3.1. Ships AC Mains
Connect the power cord from the rear panel of the MXP to AC voltage power source (UPS
power recommended).