COBHAM Sea Tel 9711-56 IMA C Band, Руководство по установке

Страница: 60 / 234

Installation in 168” Radome Sea Tel 9711-56 IMA
5-6
EAR Controlled - ECCN EAR99
5. Repeat caulking, closing and
cleaning the vertical flanges
until all of the riser panel seams
are closed.
6. Remove the tape from the
vertical seams.
7. The riser section of the radome
is now complete.
8. Set the riser panel assembly on
the base pan.
9. Loosely attach the riser panel
assembly to the base frame
using the hardware provided.
Do NOT tighten the bolts at this
time.
10. Use wedges to lift the riser
panel assembly up off of the
base pan about ½ inch.
11. Install a good bead of caulking
between the bottom of the riser
panels and the base pan,
remove the wedges, apply
Loctite to and then firmly
tighten all of the horizontal
flange bolts.
12. Clean off the excess caulking
from the inside and outside of
the radome base where the riser
panels are attached to the base.
13. Remove the tape from the
bottom edge of the outside of
the riser panels.
14. On a flat surface, loosely
assemble the 8 lower panels
using the hardware provided.
Do NOT tighten the bolts at this
time. Assure good horizontal
alignment of the panels. Good
alignment of the bottom edge
of the panels is important for
good seal on the riser panels
and good alignment of the top
provides a good seal between
the lower and upper panels.