COBHAM SAILOR 600 VSAT Ka, Руководство по установке

Страница: 108 / 178

Software update
8-6 Chapter 8: Service 98-148248-A
8.2 Software update
8.2.1 Prerequisites
The following items are required to make a software update:
• One computer with a standard Ethernet port available.
• A standard Internet browser.
• 1024×768 pixels or higher display resolution (best viewed with small fonts).
• One straight LAN cable.
• Access to the file with the new software.
8.2.2 Software update (ADU, ACU)
The upload procedure takes a couple of minutes. When done, the ACU automatically
restarts with the new software version. The start-up procedure after a software upload
takes longer than the usual start-up time, as the software in the ADU must also be updated.
This is shown in the ACU display as
ADU SW UPLOAD
.
To make a software update, do as follows:
1. Power up the SAILOR 600 VSAT Ka system, i.e. switch on the ACU. Wait until the ACU
has finished initializing.
2. Connect a PC to LAN interface 3 (Service port, standard Ethernet) of the ACU or to the
front LAN connector of the ACU.
If you want to use another LAN port to access the web interface you must configure it
according to your network requirements. See
To configure the LAN network on page 6-
24 for more information.
3. Open your Internet browser and enter the IP address of the ACU. The default IP address
is http://192.168.0.1.
4. Type in the user name
admin
and the password
1234
to access the
Dashboard
.
5. The web interface shows the DASHBOARD page.
6. Click
SERVICE
in the navigation pane. The
UPLOAD
page is displayed.
Note
Software update should only be done by qualified service personnel.
Figure 8-3: LAN 3 connector used for configuring the SAILOR 600 VSAT Ka
SAILOR600Ka-IM-98-148248.book Page 6 Monday, November 23, 2015 1:36 PM