COBHAM SAILOR 600 VSAT Ka, Руководство по установке

Страница: 160 / 178

Supported commands
D-8 Appendix D: Command line interface 98-148248-A
D.2.9 system
D.2.10 track
Command Description
system
Shows the sub commands available, including a short
description.
system restart
Sends a command to the ACU to restart the system
instantaneously. It makes a power-on self test and then
points to the last used satellite.
system info
Shows the software version, part names and serial
numbers of the SAILOR 600 VSAT Ka.
Table D-10: UCLI command:
system
Command Description
track
Shows the sub commands available, including a short
description.
track mode
track mode dvb
Shows or sets the receiver bandwidth or mode, the way
the SAILOR 600 VSAT Ka tracks the satellite:
• narrow (recommended, uses the built-in 300 kHz
filter of the SAILOR 600 VSAT Ka)
• rssi (uses the RSSI signal from the VSAT modem)
• wide (uses the wide-band filter to track the satellite)
• dvb (uses the built-in DVB-S2 receiver of the SAILOR
600 VSAT Ka to track the satellite. You must
configure
dvb_sym
and
dvb_nid
.)
• GSC (uses Inmarsat Global Signalling Channel
• GSCpwr (uses power of Inmarsat Global Signalling
Channel)
track dvb_sym
track dvb_sym 22
Shows or sets the current mega symbols rate for the
DVB-S2 receiver when in dvb mode. The symbol rate
used to verify and track a transponder.
• Valid range: 0.1 — 99
track dvb_nid
track dvb_nid 0
Shows or sets the DVB NID to be verified by the built-in
DVB-S2 tracking receiver, when using tracking mode
DVB. It configures the NID used to verify and track a
transponder.
• Valid range: 0 — 65535
A NID of ‘0’ disables the NID check. Then the NID
will be omitted in the verification of the
transponder.
Table D-11: UCLI command:
track
SAILOR600Ka-IM-98-148248.book Page 8 Monday, November 23, 2015 1:36 PM