Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 70 / 436

6
Brake Pads and Caliper
HYDRAULIC BRAKE AND PARK BRAKE
SYSTEMS
3. Caliper Only: Secure the brake hose (6) to the caliper with banjo bolt (5) and new copper washers (4) (Figure
6-3, Page 6-11) . Tighten to 146 in-lb (16.5 N·m). See following CAUTION and NOTE.
CAUTION
• The banjo bolts are metric. Use only metric thread replacements.
NOTE: Driver's side brake hose connection uses 2 hoses (6 and 9) and a double length banjo bolt (8). (Figure
6-4, Page 6-11) .
4. Fill the reservoir of the master cylinder and bleed the hydraulic system. See Bleeding the Hydraulic Brake
System on page 6-18. See following WARNING.
WARNING
• Use the top bleeding port on each caliper to bleed that respective rear wheel.
• Ensure hydraulic hoses cannot contact any moving parts that will cause wear and damage.
5. Repeat procedure for the opposite brake if necessary.
6. Install the tire and wheel. Finger-tighten the lug nuts.
7. Lower the vehicle and use a crisscross pattern to tighten the lug nuts to 85 ft-lb (115 N·m).
8. Inspect the brake system. See Brake System Inspection on page 6-1.
9. Burnish the new pads before initial vehicle operation. On a flat, open surface, accelerate the vehicle to moderate
speed, then apply the brakes under modest, steady pressure. Repeat this procedure eight to twelve times.
Page 6-12 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual