Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 397 / 436

HYDRAULIC ATTACHMENT SYSTEM Hoses
19
1
3 4
2
1. Red Hose At Pump 2. White Hose At Pump 3. White Hose At Quick Connect Fittings 4. Red Hose At Quick Connect Fittings
2251
Figure 19-35 Auxiliary Circuit Hoses
HOSE REMOVAL
1. Relieve pressure in hydraulic system. See Relieving Hydraulic System Pressure on page 19-1.
2. Set the joystick ON/OFF switch to OFF, remove driver seat and disable vehicle. See Disabling the Vehicle
on page 1-3.
3. Disconnect battery. See Side-Post Battery: Disconnecting the Battery – Gasoline/Diesel Vehicles on page
1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
4. Thoroughly clean the hose fittings and the area around the ends of the hose being removed (Figure 19-34,
Page 19-22) .
5. If removing more than one hose at a time, locate and note the hose factory color marking to ease reassembly.
See following NOTE.
NOTE: Mark hoses for correct installation if factory markings are not found.
6. Disconnect hose at each end. Cover hose ends and fittings to keep out debris. See following NOTE.
NOTE: Contain and dispose of any leaking oil in an environmentally safe manner.
7. Cut wire ties securing hose to chassis and remove hose from vehicle.
HOSE INSTALLATION
1. Reverse the removal procedure to install hose(s).
1.1. Make sure to match factory color marking to correct fitting (Figure 19-34, Page 19-22) .
1.2. Secure with wire ties at all factory established locations.
1.3. Tighten hose fittings to 22 ft-lb (30 N·m).
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual Page 19-23