Club Car Carryall 1500 2016, Руководство по техническому обслуживанию и ремонту

Страница: 360 / 436

17
Transmission DRIVETRAIN COMPONENTS
5. Advance the front flanged nut, closest to the transmission shifter arm, up against the front side of the cable bracket.
6. Advance the rear flanged nut, farthest away from the transmission shifter arm, down next to the back side of the
cable bracket and tighten the front nut to 25 ft-lb (34 N·m).
7. Move the shifter handle to the FORWARD, NEUTRAL, and REVERSE positions.
7.1. Ensure shifter handle is clear of the instrument panel in the FORWARD and REVERSE positions.
7.2. Ensure shifter handle is centered between those positions in the NEUTRAL position.
8. Install the passenger seat.
9. Lower and secure the hood.
10. Gasoline vehicles: Connect the spark plug wires.
11. Connect battery. See Side-Post Battery: Connecting the Battery – Gasoline/Diesel Vehicles on page 1-4.
See Top-Post Battery: Connecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
FORWARD/REVERSE SHIFTER HANDLE
7
8
3
4
2
1
5
4
6
2568
Figure 17-14 Shifter Handle Components
Shifter Handle Removal
1. Disconnect battery and spark plug wire(s) (gasoline vehicles only) . See Side-Post Battery: Disconnecting
the Battery – Gasoline/Diesel Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2. Remove the shifter knob (1) (Figure 17-14, Page 17-12) .
3. Raise the hood.
4. Disconnect cable end from Forward/Reverse shifter handle (2) in the dash by removing clip (Figure 17-13,
Page 17-11) .
5. Remove the socket-head pivot shoulder bolt (3), two large flat washers (4), bushing (5), and nylon locknut (6)
from the shifter handle and frame bracket
(Figure 17-14, Page 17-12) .
6. Remove the shifter handle (2).
7. Remove cable pin (7) and locknut (8) from the shifter handle (2).
Shifter Handle Installation
1. Secure the shifter handle (2) with a new socket-head pivot shoulder bolt (3) (CC P/N 102684603), bushing (5),
two large flat washers (4), and a new nylon locknut (6) as shown
(Figure 17-14, Page 17-12) . Tighten locknut (6)
to 40 in-lb (5 N·m). See following NOTE.
Page 17-12 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual