CLAS EQ 1000, Руководство пользователя

Страница: 71 / 76

71
EQ 1000
MOTORIZED WHEEL BALANCER WITH DIGITAL DISPLAY
026
A launch without weight or failure of the pick-up A
signal in the Cal2 calibration phase.
Apply the intended weight and repeat the launch. If the error
persists, contact technical support.
027
A launch without weight or failure of the pick-up B
signal in the Cal2 calibration phase.
Mettre la masse et recommencer la calibration.
Si l’erreur persiste, contacter le SAV.
028
A launch with weight on the internal side during the
Cal3 calibration pha- se. In this phase, the weight must
be on the external side.
Remove the weight from the internal side and repeat the launch.
If the error persists, contact technical support.
029 RESERVED
030
Lack of calibration data for the CAR/ SUV (auto-vehicle
and off-road) Wheel Type
Carry out calibration for the CAR/SUV wheel Type.
031
Lack of calibration data for the MOTO (motorbike)
Wheel Type
Carry out machine calibration for the MOTO Wheel Type.
Acoustic signals
The machine gives special visual signals in certain cases. The special visual signals are listed in table T10.3
Table T10.3 – Special visual signals
Signal Meaning Notes
Short beep Selecting a programme or a function -
Long beep Acquisition
Acquisition of a value (e.g. acquisition of wheel
dimensions).
Double beep Warning
A particular condition has occurred that requires
the operator’s attention.
Triple beep Function not available or Error
The requested function is not available or that an
error condition has occurred.
Short beep + long
beep
Storing one or more values in the permanent memory
(eeprom) of the circuit board
One or more values have been stored in the
permanent memory of the circuit board (for
example, at completion of calibration phases).
Intermittent beep Adjustment
Signal used in some service programmes to
simplify the adjustment of sensors.
The acoustic signal is also heard for about two seconds at machine start up allowing the operator to check the
operation of the alarm (buzzer).
Special visual signals
The machine gives special visual signals in certain cases. The special visual signals are listed in table T10.3
Table T10.3 – Special visual signals
Signal Meaning Notes
Three dots lit on one or
both displays
Imbalance exceeds 999 grams
This signal can be triggered due to:
• Lack of machine calibration;
• incorrect measures of the wheel dimensions.
• incorrect setting of the Wheel Type;
• incorrect setting of the Programme Type.
Flashing green STBY
LED
The machine is in the STAND-BY
mode
All LEDs and displays are switched off. To exit the STAND-BY mode, press
any button (with the exception of [P7].
The left (or right)
display is fl ashing
a) Attending the user’s command
b) The Diameter or Width sensor
is not calibrated
a) The user’s command may be the pressing a key to confi rm or continue
the procedure in progress or the selecting of a value or a menu option.
b) Call the technical support to carry on with the calibration of the Diameter
and Width sensor. To continue with the operation, you can temporarily
disable the sensors by pressing [F+P2] .