CLAS EQ 1000, Руководство пользователя

Страница: 58 / 76

EQ 1000
MOTORIZED WHEEL BALANCER WITH DIGITAL DISPLAY
Note: If the position is signifi cantly different from the vertical one, the machine will reject running the launch
by emitting an acoustic error message (triple beep). If the fl ange for motorbikes is close enough to the vertical
position but not perfectly vertical, the machine will run the launch but at the end of the calibration procedure, all
balancing launches will present an error indicating the angular position of the balancing weights;
10. At the end of the launch, the machine will display the writing CAL h12.
Apply the calibration weight on the external side as shown in Figure F4.3.
The calibration weight is to be applied on the hole that has the wording
“CAL” marked on it.
Figure F4.3. Application of the sample weight
on the external side of the fl ange for motorbikes on the shaft (Cal3 phase)
11. Bring the fl ange for motorbikes in perfect vertical position with the calibration weight at the top part as shown
in fi gure F4.3 and press the [P8] Start or lower the wheel guard. If the position is signifi cantly different from the
vertical one, the machine will reject running the launch by emitting an acoustic error message (triple beep).
12. Once the calibration launch for the MOTO Wheel Type is completed, the machine returns directly to the
NORMAL mode, ready to perform the balancing.
When the machine completes calibrating, the MOTO Wheel Type and the ALU1 Programme Type will remain set.
Even the dimensions of the wheel will remain those set automatically by the machine for this type of calibration.
If there are some anomalies during machine calibration, error codes will be displayed (e.g. Err 025). See chapter
10.1 (Error Codes) and act accordingly to eliminate the problem and to continue/repeat/cancel the calibration
in progress.
The launches interrupted by pressing [P10] Stop or by raising the wheel guard may be repeated by pressing [P8]
Start or by lowering the wheel guard.
How to exit from auto-vehicle calibration mode for the MOTO Wheel Type
You can exit the ongoing calibration procedure at any time by pressing [F+P3]. The machine will return to the
SERVICE mode displaying the writing SER SER.
To return to the NORMAL mode, press [F+P3] again.
The calibration in progress will be cancelled and the balancing results will use the calibration results for the MOTO
Wheel Type previously used.
Even in this case, the MOTO Wheel Type and the ALU1 Programme Type will remain set and the dimensions of
the wheel will remain those set automatically by the machine for this type of calibration.