5-6
Cisco SFS 3504 Multifabric Server Switch Hardware Installation Guide
OL-14325-01
Chapter 5 Cisco SFS 3504 Server Switch LEDs
Ethernet Gateway LEDs
Ethernet Gateway LEDs
Each Ethernet gateway has two
types of LED indicators. This section describes the LEDs on the Ethernet
gateway and includes the following topics:
•
Ethernet Gateway Card Status LEDs, page 5-6
•
Ethernet Gateway Port Status LEDs, page 5-7
Figure 5-3
shows the location of the Ethernet gateway LEDs and the Ethernet port status LEDs.
Figure 5-3
Location of Ethernet Gateway and Ethernet Port LEDs
Ethernet Gateway Card Status LEDs
Each Ethernet gateway card includes two LEDs (one green and one yellow) as shown in
Table 5-5
. These
indicators describe the Ethernet card status.
Table 5-6
describes the LED indicators. The OK label is for
the green LED and the ! label is for the yellow LED.
250274
SFS3500 Series Ethernet Gateway
!
OK
1
2
3
4
6
TX/RX
Link
100/1000Base T
5
!
OK
6
TX/RX
Link
1
2
1
Ethernet gateway card status LEDs (1 green
and 1 yellow)
2
Ethernet gateway port status LEDs
(both green)
Table 5-6
Ethernet Card Status LED Indicators
LEDs
Indicators
OK Label
! Label
Off
Off
Gateway card power not enabled, or LED failure, or power
failure
Fast Blink
Off
Gateway card initializing after power on or reset
On
Off
Gateway card operational with no errors detected
Off
On
Gateway card error detected: power, temperature, or
electronics. Operator intervention is required
Slow blink
Slow blink
LED test following power on condition: Both LEDs blink
slowly (1/4 Hz.)
Off
Fast Blink
Identify the gateway card by causing it to blink by using the
CLI