Cisco IE 4000, Руководство по настройке программного обеспечения

Страница: 612 / 1066

608
Configuring QoS
Configuring QoS
Use the no form of the appropriate command to delete an existing class map or remove a match criterion.
This example shows how to create access list 103 and configure the class map called class1 . The class1 has one match
criterion, which is access list 103. It permits traffic from any host to any destination that matches a DSCP value of 10.
Switch(config)# access-list 103 permit any any dscp 10
Switch(config)# class-map class1
Switch(config-cmap)# match access-group 103
Switch(config-cmap)# exit
This example shows how to create a class map called class2 , which matches incoming traffic with DSCP values of 10,
11, and 12.
Switch(config)#
class-map match-any class2
Switch(config-cmap)# match ip dscp 10 11 12
Switch(config-cmap)# exit
This example shows how to create a class map called class3 , which matches incoming traffic with IP-precedence values
of 5, 6, and 7:
Switch(config)# class-map match-any class3
Switch(config-cmap)# match ip precedence 5 6 7
Switch(config-cmap)# exit
This example shows how to create a parent class-map called parent-class , which matches incoming traffic with VLAN
IDs in the range from 30 to 40.
Switch(config)# class-map match-any parent-class
Switch(config-cmap)# match vlan 30-40
Switch(config-cmap)#
exit
Configuring Table Maps
You can configure table maps to manage a large number of traffic flows with a single command. You use table maps to
correlate specific DSCP, IP precedence and CoS values to each other, to mark down a DSCP, IP precedence, or CoS
value, or to assign default values. You can specify table maps in
set commands and use them as mark-down mapping
for the policers.
These table maps are supported on the switch:

DSCP to CoS, precedence, or DSCP

CoS to DSCP, precedence, or CoS

Precedence to CoS, DSCP, or precedence
Note these guidelines when configuring table maps:

The switch supports a maximum of 256 unique table maps.

The maximum number of map statements within a table map is 64.

Table maps cannot be used in output policy maps.

Table maps are not supported for violate-action for aggregate policing unless you configure a table map for
exceed-action and no explicit action is configured for violate-action.
Beginning in privileged EXEC mode, follow these steps to create a table map: