6-13
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 6 Installing the Router
Additional Router Connections
Figure 6-7
Chassis Cable Ports—For Cabling to External Connectors or Devices
Using Cable Glands
This section describes how to use cable glands with router cables that are threaded through the chassis
cable ports that are described in the
“External Connections and Chassis Cable Ports” section on
page 6-12
.
Caution
The cable glands must be used for all cables that are threaded through the router chassis cable ports to
prevent exposing the router interior to environmental elements.
Ordering Cisco Cable Glands
You can order a cable gland kit from Cisco using the model number CGR-IP67GLAND. Each kit
contains one cable gland. See the
“Router Hardware Description”
chapter for detailed information about
this part.
Tools You Supply
You must supply:
•
13-mm box-end wrench or socket set to remove port seals from the router
•
15/16-inch (24 mm) open-end wrench
Item
Description
1
These two ports on the router base are reserved for SPF module cables. One of these ports is
shown with the port plug that must be used when the port is not in use.
2
These two ports on the router door are reserved for non-Cisco module cables.
300590
1
1
2