3.5 Basic Operation (Cont.)
NOTE:
All temperature readings in the instructions below are given in degrees Fahrenheit (
°
F).
Pressure readings are given in pounds per square inch (PSI).
All models provide a metric option to display temperature in degrees Celsius (
°
C)
and pressure in kilopascals (kPa). Temperature readings and error codes are followed
by the letter "C" when the metric option is enabled.
3.5.1 Operating the UH-100B and UH-100, and UL-100
(If the START button is pushed during initial fill the Start LED will illuminate indicating that a cycle has been
selected but the machine will complete the fill before the cycle begins.
Model UH-100B, UH-100
Run one automatic cycle WITHOUT DISHES to bring the dishwasher to operating temperature.
UH-100B, UH-100 minimum wash temperature of 150
°
F/66
°
C.
UL-100 minimum wash temperature is 120
°
F/49
°
C. The optimum temperature for UL-100 is 140
°
F/60
°
C.
Push the START Button:
The Start LED illuminates and the automatic cycle begins. Detergent pump adds detergent.
Wash pump runs.
Wash pump stops, machine drains the water out of the wash tank.
(continued on next page)
Push the POWER Button:
All LEDs illuminate and 888F flash on displays.
Internal diagnostics displays Error Codes: E0, E1, E2 in temperature
display if problem exists.
Power LED lit. LOF displayed if wash temp is below 115
°
F, actual wash temp
displayed above 115
°
F/46
°
C.
PRIME button(s) are active whenever the temperature is displayed. (UL-100 has three PRIME buttons)
Machine Fills.
Wash tank heat on (UH-100B, UH-100). Booster heat on (UH-100B only).
Model UL-100 does not have tank heat.
Champion
POWER
START
EXTENDED
WASH
PRIME
TEMPERATURE
LO
DETERGENT
SANITIZER
PRIME
RINSE AID
Champion
POWER
START
EXTENDED
WASH
PRIME
TEMPERATURE
150 F
(140
°
F/60
°
C for UL-100)
Part 3:
DAILY OPERATION
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor