Part 2:
INSTALLATION
2.11 Initial Start-up (Cont.)
2.11.2 Models UH-100B, UH-100, UL-100
Push the POWER button.
• 888F, and LED's flash on display
• No error codes (E0, E1, E2)
• Machine fills, LO display is normal.
• Detergent pump runs (if applicable)
Open door and check water level in tank
• (UH-100B, UH-100) Water level even
with the bottom of the round scrap screen
• (UL-100) Water level even with the
top of the handle on the round scrap screen
Close door.
• Check for leaks around dishwasher.
Check wash tank minimum operating temperature.
• (UH-100B, UH-100) minimum 150
°
F/66
°
C.
• (UL-100) minimum 120
°
F/49
°
C, optimum 140
°
F/60
°
C.
Push START button.
• Check for leaks.
• Dishwasher completes normal cycle.
• Final rinse temperature reaches minimum of 180
°
F/82
°
C for UH-100B, UH-100.
• Final rinse temperature maintains minimum of 120
°
F/49
°
C for UL-100.
Push POWER button.
• Displays flash 888F
• Dishwasher completes auto-shutdown cycle.
• Check for leaks in drain piping.
Push the POWER button.
• Machine fills again.
Push START button.
• Machine begins cycle
Push EXTENDED WASH button.
• Wash cycle holds in continuous wash mode
• Extended wash LED illuminates.
Push EXTENDED WASH button.
• Wash cycle returns to normal wash mode
• Extended wash LED goes out.
• Normal cycle completed.
Push POWER button.
• Displays flash 888F
• Dishwasher completes normal auto-shutdown cycle.
• Initial Start-up is complete.
√
√
√
√
√
√
√
√
√
√
√
FILL
DETERGENT
SANITIZER
RINSE
AID
9
1
5
6
4
3
7
2
8
0
10
9
1
5
6
4
3
7
2
8
0
10
9
1
5
6
4
3
7
2
8
0
10
9
1
5
6
4
3
7
2
8
0
10
9
1
5
6
4
3
7
2
8
0
10
DOTS
ON
END
OF
POTENTIOMETER
NOTE:
Refer to Part 7, Section 7.3.5,
pages 66-67, for instructions
on adjusting the fill water
level for Models UH-100B,
UH-100, and UL-100
dishwashers.
UL-100
Water Level
even with top
of screen handle
UH-100B, UH-100
Water Level
Halfway up the
sloped angle of
screen handle
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
