4. Enter the Jog Parameters Menu:
From the main menu, press
F1 Setup
→
F3 config
. The password is
137
.
Press
F2 Mach.
→
F1 Jog
.
In the Jog Parameters menu. Enter the DRO value into the appropriate
Travel (-)
or
Travel (+)
box, whichever is
opposite
the side the machine homes to. Refer to figure 6.9.3.
Note:
When both the Travel(-) limit and the ) limit are set to zero, software travel limits are disabled. As soon
as
one
of the two values change to a non-zero value,
both
limits are enabled. Since everything is referenced to
machine position, the side of each axis that you home to should be left at zero.
5.
Repeat for each axis.
6. Test by manually jogging each axis toward the limit switch:
Ensure that the machine automatically stops the axis at
the software travel limit
before
the limit switch is tripped.
Use the
F3 MDI
menu to issue a G-code that asks the software to move just beyond the software travel limit, verify the
CNC11 status window throws an error such as
907 # axis travel exceeded, 325 Limit: job canceled
Page 51 of 72
6.9 Software Travel Limits
T:\_Docs working\Oak Board Manual\Oakboard install manual V2 4-10-15.odt
Figure 6.9.3
Setting Software Travel Limits
alt + D
to toggle
the DRO mode
to display the
machine
cordinates.
Set up software travel limits here.
Содержание OAK
Страница 3: ......
