Centroid 13126, Инструкция по установке

Страница: 61 / 86

C
HAPTER
7 A
PPENDICES
A
PPENDIX
A - T
ROUBLESHOOTING
Symptom Or Error Troubleshooting
Error Initializing MPU11
•
Firewall or antivirus problem, see Section 3.1.
•
Ethernet Cable is not shielded, see Section 2.3.
•
Lack of power to the Oak Board.
•
An incorrect IP configuration, see Section 3.2.9.
For further troubleshooting, refer to TB 279:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/279.pdf )
452 PC Receive Data
Error
Most often caused by noise.
•
Ensure the Ethernet cable is shielded, it will have metal clips on each end. See Section
2.3.
For further troubleshooting, refer to TB 270:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/270.pdf )
Jog Panel Communication
In Fault
•
If the optional Jog Panel/Pendant will not be installed, change the “Jog Panel
Required” to “No” in the control configuration screen.
Power off the system and restart.
•
If the optional Jog Panel/Pendant was ordered, confirm that it is plugged at both the
Oak Board and on backside the Jog Panel board itself on the header labeled CPU10.
For more information see TB 282:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/282.pdf )
Axis does not move the
correct distance The motor revs/inch, or mm's/rev, has not been set correctly.
Ensure you have properly calibrated your machine. Section 6.5.
For more information see TB 36:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/36.pdf )
Axes don't move – No
Error or Fault displayed
•
The feedrate override is turned down to zero. Confirm that the feedrate override is set
to ~100%.
•
E-Stop button is depressed. Release the E-Stop button, the “Emergency Stop
Released” message should appear.
•
The control is in
incremental jog mode. If
the LED is lit on the
INCR/CONT key, the
control is set to
incremental jog. Press