Centroid 13126, Инструкция по установке

Страница: 17 / 86

C
HAPTER
3 S
OFTWARE
I
NSTALLATION
3.1 W
INDOWS
S
OFTWARE
P
REINSTALLATION
1. If you have purchased a console unit or computer from Centroid, it already comes with Windows properly configured and
the CNC12 software already installed. If you bought or built your own computer, it must meet the prerequisites listed on
the Centroid Website here
http://www.centroidcnc.com/cnc_pc_performance_requirements.html and Tech Bulletin 273 -
Centroid CNC PC Minimum Hardware and Benchmark Requirements
2. To configure your own computer running Microsoft Windows 10, please use the CNC12 Windows 10 Setup Video
https://youtu.be/Akmw8ak_TlM . Once done following the video, skip to 4.1 CNC12 Software Configuration .
Appendix A below contains Technical bulletin 309 which covers this topic as well.
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/309.pdf
Note: Microsoft Windows 10 is supported with CNC12. Microsoft Windows 8.1, 7 and older versions of Windows are not
supported. Mac OS and Linux operating systems are also not supported.
3. Before installing CNC12 all anti-virus, anti-malware, and 3rd party firewall software should be uninstalled (not
disabled) and your computer rebooted.
1) Nearly 100% of all communication problems between CNC12 and the ALLIN1DC are caused by anti-virus and
3rd party firewall software.
Virus software works by stopping unusual or suspicious behavior in software, and will
almost always detect the interaction between the ALLIN1DC and the PC as unusual/suspicious and interfere with the
operation of CNC12. Firewalls work by blocking certain communication ports, and often these ports are needed for the
operation of CNC12. The default firewall built into Microsoft Windows will work fine with CNC12 if you allow access as
specified in this manual.
2) If your corporate policy requires anti-virus software, a third party firewall, or that certain Windows security features be
enabled to connect to the network, then Centroid recommends that you keep any computers with CNC12 installed
disconnected from the network.
Page 17 of 86 Chapter 3 Software Installation