Centroid 13126, Инструкция по установке

Страница: 45 / 86

4. Set Mode: CNC 12 can either be in velocity or precision mode.
•
Go to the parameters menu (From the main menu press F1 Setup → F3 Config. Password 137 . Press F3 Parms. )
◦
If using velocity mode (Estun Drive): Set parameter 256 to 1 .
◦
If using precision mode (Yaskawa or Delta Drive): Set parameter 256 to 2 .
5. Verify Heating / Cooling Parameters: Heating and cooling do not apply for 3 rd party drives.
Go to the parameters menu. (From the main menu press F1 Setup → F3 Config. Password 137 . Press F3 Parms. )
Set parameters 21- 24 to 0 and 132 – 135 to 0 .
Make sure the cooling coefficients (parameters 25 – 28 and 236 – 239 ) are set to their default value of “ 0.68 ”.
Press F10 to save when finished.
Figure 6.1.2
Setting up the Drive Output
and Encoders
Figure 6.1.3
Heating Coefficients
Disabled
Axis 1
Axis 2
Axis 3
Axis 4
Encoder 1
Encoder 2
Encoder 3
Encoder 4
Spindle Encoder
These parameters set
at 1 mean the drive
plugged into the axis 1
header will correspond
with the first axis from
Figure 6.1.1