Centroid 13126, Инструкция по установке

Страница: 59 / 86

4. Enter the Jog Parameters Menu: From the main menu, press F1 Setup → F3 config . The password is 137 .
Press F2 Mach. → F1 Jog .
In the Jog Parameters menu. Enter the DRO value into the appropriate Travel (-) or Travel (+) box, whichever is
opposite the side the machine homes to. Refer to figure 6.10.3.
Note: When both the Travel(-) limit and the ) limit are set to zero, software travel limits are disabled. As soon
as one of the two values change to a non-zero value, both limits are enabled. Since everything is referenced to
machine position, the side of each axis that you home to should be left at zero.
5. Repeat for each axis.
6. Test by manually jogging each axis toward the limit switch: Ensure that the machine automatically stops the axis at
the software travel limit before the limit switch is tripped.
Use the F3 MDI menu to issue a G-code that asks the software to move just beyond the software travel limit, verify the
CNC12 status window throws an error such as 907 # axis travel exceeded, 325 Limit: job canceled
Figure 6.10.3
Setting Software Travel Limits
alt + D to toggle
the DRO mode
to display the
machine
cordinates.
Set up software travel limits here.