Centroid 13126, Инструкция по установке

Страница: 50 / 86

Use MDI to move each axis and determine if the axis is moving in the correct direction. To determine this, observe that the DRO
counts up while moving a tool in the positive direction and that it counts down while moving in the negative direction.
To correct for an axis that is moving in the wrong direction:
1. From the main menu press F1 Setup → F3 Config . Password 137 . Press F2 Mach → F2 Motor .
2. Use the arrow keys to select the Dir Rev field for the axis that needs to be reversed.
3. Press the space bar to change it's state.
Refer to Figure 6.4.3.
Figure 6.4.3
Direction reversal