Centroid 13126, Инструкция по установке

Страница: 23 / 86

C
HAPTER
4 C
ONFIGURING FOR A
B
ENCH
T
EST
4.1 B
ENCH
T
EST
– CNC12 S
OFTWARE
C
ONFIGURATION
Relevant martyscncgarage video:
Centroid CNC Oak CNC12 4 14 Software Install and Oak Benchtest
Start the CNC12 Software, you should see the screen in figure 4.1.1.
1. Enter the Software Unlock Demo Code To enter a software unlock press F1-Unlock Option as shown in Figure 4.1.1.
In “Enter Unlock #:” enter 297 for demos or 298 for permanent unlocks as shown on your unlock sheet . Press ENTER.
Look at the value in the “Software Unlocks” sheet that shipped with control. Enter the value next to the unlock number.
Press
ENTER . Continue to the main menu.
2. Did you install the correct PLC program? Access the options screen again by pressing F7 – Utility → F8-Option →
F1-Unlock Option . This time the options screen should contain some additional information. Look for a box labeled “ MPU
PLC ” as shown in Figure 4.1.2, check to make sure the correct PLC program is installed. For a mill, the PLC program
should read “ Centroid-Mill-Standard-OAK-r4.src ” or newer. If your program is not version 2 or newer, it does not
support over-riding of the I/O. Therefore, older versions are not support by this documentation.
3. Install All Other Unlocks Enter all unlocks provided on your unlock sheet using F1-Unlock Option like you did earlier. If
you have a permanent unlock AND a demo mode code, install both . This will put the features you did not purchase into
“Demo mode” allowing you to try out such features as rigid tapping, Intercon, or DXF Import. When the demo expires, the
software add-ons labeled “
DEMO ” will go away and any options labeled “ ON ” will remain. To get back to the main menu
from the Software Add-Ons menu screen press the Esc key.
In general, when using CNC12, you can always go back one
menu level by pressing the escape key (
ESC ). Tapping escape
multiple times from any menu will take you back to the main
menu.
From now on when using CNC12, you can always go up one menu level by pressing the escape key ( ESC ). Tapping escape
multiple times from any menu will eventually take you back to the main menu.
Page 23 of 86 Chapter 4 Configuring for a Bench Test
Figure 4.1.1
Options screen
Figure 4.1.2
Entering Unlocks