Centroid 13126, Инструкция по установке

Страница: 54 / 86

6.7 H
OMING THE
M
ACHINE
1. Configure Limit Switches:
Note: Information on homing to reference marks can be found in Technical Bulletin 127.
( http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/127.pdf )
1) Bring up the Real Time I/O screen: Press Alt+i
◦
If any inputs are still inverted, highlight them and press Ctrl+Alt+i to remove any bars over inputs 1-6
2) Manually trip the -X limit switch by physically pressing it / blocking it. Take note of which input changes color,
this input is the -X limit switch.
3) Enter the motor parameters menu: From the main menu press F1 Setup → F3 Config . Password 137 . Press F2
Mach → F2 Motor .
4) Enter the input number of the tripped limit switch.
◦
Example: If input 1 turned red when the -X limit switch was tripped, enter 1 into the -X field in figure 6.6.1
(highlighted)
5) Repeat for the + and – limits for other axes.
6) Continue to step 2.
Figure 6.6.1
Reversing limit switches in software