.
Terminologies Used
.
KTS Lines
- KTS Extension lines that can be connected to KTS Instruments.
JUNCTION LINES
- Telephone Lines provided by the Department of Telecom.
EXTENSION LINES
- Extension Lines mean the EPABX extension lines that can be connected to SLT Telephone Sets.
Note
:
The first 4 Ports of the PBX numbered 601 to 604 can be connected to SLT as well as KTS Instruments.
.
Programming the PBX
.
To program most of the feature mentioned in this manual, programming Password is to be entered from any of the first 4 KTS/SLT
extensions (601, 602, 603, 604) through the following command
:
#
0000 (Here, 0000 is the default Password)
In case of any mistake while programming, dial
to reset or else keep the Handset down and pick up again.
Whenever a correct input is entered, PBX will give one single acceptance tone and when wrong input is given, it will give three
tones.
.
Alarm
.
Alarm calls can be set for extensions from any of the programming extensions (or even from own extension) as described below
:
To set Alarm from SLT programming extensions:
Dial #
0000 05 NN HH MM #
Where, NN = Last 2 digits of the extension number
HH = 00
– 23 Hours
MM = 00 - 59 Minutes
Dial #
0000 05 # (To clear Alarm of all extensions)
Dial #
0000 0
5 NN # (To clear Alarm of “NN” extension)
To set Alarm from your own SLT extension:
Dial # 4 HH TT
To set Alarm from KTS:
Lift H # 4
Use Jog Dial to select Extension and to enter the Time
Press “SP-PHONE” key to select any of the parameter.
Press “SP-PHONE” key again to Exit.
Alternately, use the following process:
Press program key once -> Press down arrow nine times -> Press right arrow -> Set the extension ->
Press right/ left arrow -> Set Time -
> Press “Hold/ Store” Key -> Press “SP-PHONE” key to Exit
.
Allowed Table
.
Numbers to be allowed to extensions whose L = 0, are to be defined in this table.
For value of L refer “Junction Dialing Controls”.
This table has 16 Locations.
Procedure
:
Dial #
0000 + 43 QQ ABCD#
Where QQ= 01 to 16 (16 Locations of the Table)
ABCD= The starting 9 digits of the Tel numbers to be allowed to extension.
For less than 9 digits, dial # at the end of digits.
To clear this Table:
Dial #
0000 + 43 #
To clear a particular location of this table:
Dial #
0000 + 43 QQ #
.
Auto Call Back
.
From Busy Junction Lines
To get a call back when any of the busy Junction lines get free,
Dial 9
Get engaged tone
Dial #