Between 2 Extension & 1 Junction
Following is the procedure to established conference between 2 Extensions and a Junction line
:
From SLT Extension
During conversation with a Junction line, Hook-Flash to hold the line.
Then dial
XXX Where, XXX = Extension Number.
From KTS Extension
During conversation with a Junction line, press “CONF” Key
Dial Extension Number
Press “CONF” Key
Conference will start
Between 1 Extension & 2 Junction
From SLT Extension
During conversation with a Junction line
FLASH
Dial ##
Pick up another Junction by dialing 9 & dial required Tel number
FLASH
Dial #
Conference will start.
To end the conference, extension has to keep handset down.
From KTS Extension
During conversation with a Junction line
Press CONF Key
Press DSS key of a free Junction
Dial required Tel number
Press CONF Key
Conference will start.
When KTS keeps Handset down, the conference will end.
Between 2 Junction
From SLT Extension
During conversation with a Junction line
FLASH
Dial ##
Pick up another Junction by dialing 9 & dial required Tel number
FLASH
Dial # 6
Conference will start.
Extension can keep the Handset down but cannot use its extension for any other purpose until the conference is
over.
Extension will ring once every 20 secs to remind about the conference
Whenever the Extension picks up, it will join the conference but on keeping the handset down this time, the
conference will end.
From KTS Extension
During conversation with a Junction line
Press CONF Key
Press DSS key of a free Junction
Dial required Tel number
Press CONF Key
Conference will start.
Press CONF Key again
Keep the Handset down
Conference will continue between the 2 Junction lines
KTS will ring once every 20 secs to remind about the conference
KTS can over hear the conference anytime by simply lifting the handset
To allow the conference to continue, KTS should press CONF key and keep handset down
To end the conference keep Handset down without pressing CONF key
