Case CX300C, Руководство оператора

Страница: 230 / 288

6 - MAINTENANCE
3. Place a receptacle of a suitable capacity under the
upperstructure frame, remove the oil drain plug (1) and
allow the oil to flow out.
NOTE: The oil takes a relatively long time to drain.
ATTENTION: Check the condition of the drained oil. If
it contains metal filings or foreign matter, consult your
CASE CONSTRUCTION Dealer.
4. Install the drain plug (1) .
LOX1WD-011A
3
5. Add oil through the filler hole (1) until the level is cor-
rect.
6. Install the dipstick (1) .
7. Wait ten minutes and then use the dipstick (1) to check
the oil level again. If necessary, add more oil through
the filler hole
(1) .
MMYFQD-009
4
Greasing the swing reduction gear
Remove the lower panel, remove the air bleed plug (1)
and refill with grease through the grease point (2) .
A certain amount of grease should run out from the air
bleed plug
(1) .
Install the air bleed plug (1) then install the lower panel.
NOTICE: When greasing, the inner seal will be damaged
if the air bleed plug (1) is not removed.
ELVIVS-005
5
6-48