Case CX300C, Руководство оператора

Страница: 205 / 288

6 - MAINTENANCE
Cooling system
CAUTION
Burn hazard!
Take care if removing the filler cap while the system is hot. Before removing the cap: completely cover
the cap using a thick cloth, and slowly open the filler cap to allow the pressure to escape. Do not add
cold water to a hot coolant reservoir.
Failure to comply could result in minor or moderate injury.
C0031A
WARNING
Hazardous chemicals!
Coolant can be toxic. Avoid contact with skin, eyes, and clothing. Antidotes:
EXTERNAL - Rinse thoroughly with water. Remove soiled clothing.
INTERNAL - Rinse the mouth with water. DO NOT induce vomiting. Seek immediate medical attention.
EYES - Flush with water. Seek immediate medical attention.
Failure to comply could result in death or serious injury.
W0282A
Service specifications
Expansion reservoir level check: Every 10 hours or every day
Checking the tightening of clamps, of radiator hoses: Every 250 hours or every 6 months
Draining the system (long duration): Every 1000 hours or every 2 years
Draining the system (with anti-freeze) (spring and autumn): Twice a year
System capacity:
30.8 l ( 8.1 US gal )
Type of coolant: (Refer to page 6-5 )
NOTICE: Check and service the cooling system according to the instructions given in this manual.
Coolant solution
Put only ethylene-glycol coolant solution in the cooling system. Use good quality ethylene-glycol that has a high
boiling point, with no additives to prevent leakage. Do not use non-approved anti-rust additives. Anti-rust additives
and ethylene-glycol can mix and work against each other, thereby reducing anti-corrosion protection, forming deposits
in the cooling system and causing damage to the cooling system and radiator.
Consult your CASE CONSTRUCTION Dealer who will supply you with the suitable coolant.
Level
The level of coolant solution should be checked when the
engine is cold.
On flat, level ground, before using the machine (while the
engine is still cold), the level in the expansion reservoir
should be between the "
Full " (1) and " Low " (2) marks.
If not, see "Filling".
MMYFQD-006
1
6-23