Case CX300C, Руководство оператора

Страница: 151 / 288

4 - OPERATING INSTRUCTIONS
Operating the machine
Operating the machine in water
Make sure that the bottom of the stream, or stretch of
water in which you will work, can support the weight of
the machine.
Only the undercarriage must be below water level. The
maximum water level can be up to the height of the tracks
is
1.00 m ( 39.37 in ).
ATTENTION: Never work in water if the water level is
higher than the tracks.
Before working in water, grease the attachment linkage,
turntable bearing and turntable bearing teeth generously.
ATTENTION: Do not operate in a fast flowing stream.
EQP769-003
1
Operating the machine on sloping ground
WARNING
Driving hazard!
Hillside operations can be dangerous. Rain, snow, ice, loose gravel, or soft ground, etc. can change
the ground conditions. You must make a judgment if it is safe to operate your machine on any hillside
or ramp.
Failure to comply could result in death or serious injury.
W0144A
WARNING
Overturning hazard!
Before parking the machine, make sure the ground is stable. Plan the worksite so that the ground is
flat, hard, and level.
Failure to comply could result in death or serious injury.
W0258A
During hillside operations, be extra careful.
• Make sure that the low speed travel is selected.
When digging on a slope, avoid swinging the upperstructure towards the bottom of the slope with the backhoe
bucket full.
• Always keep the travel reduction gears pointing down towards the bottom of the slope.
• Always travel in the same direction as the slope, to prevent the machine from turning over.
4-21