Canon XF205, Инструкция по эксплуатации

Страница: 219 / 246

219
Troubleshooting
Eng
lis
h
Playback
Cannot delete MXF clips.
- You cannot delete MXF clips with an
$
mark. Remove the
$
mark (
A
153) to delete the clip.
Deleting clips takes longer than usual.
- When the recording media contains a large number of clips, some operations may take longer than usual. Save your
clips (
A
168) and initialize the recording media (
A
41).
Cannot delete MP4 clips/photos.
- The LOCK switch on the SD card is set to prevent accidental erasure. Change the position of the LOCK switch.
- Photos that were protected using other devices cannot be deleted with the camcorder.
Cannot copy MXF clips.
- There is not enough available space on the CF card being copied to or the CF card already contains the maximum
number of clips (999 clips). Delete some clips (
A
154) to free some space or replace the CF card.
Indicators and Onscreen Displays
ì
appears in red on the screen.
- Battery pack is exhausted. Replace or charge the battery pack.
í
appears on the screen.
- The camcorder cannot communicate with the battery pack attached so the remaining battery time cannot be
displayed.
The tally lamp does not illuminate.
- Set [Other Functions]
>
[Tally Lamp]
>
[Front] and/or [Rear] to [On].
The tally lamp flashes quickly. (4 flashes per second)
- The battery pack is exhausted. Replace or charge the battery pack.
- There is not enough available space on the recording media. Delete some clips (
A
154) to free some space or replace
the recording media.
- A system error has occurred. Turn off the camcorder and back on again. If this does not solve the problem, consult a
Canon Service Center.
The tally lamp flashes slowly. (1 flash per second)
- The combined available space on both CF cards is low. Replace the CF card that is not being recorded onto.
- Available space on the SD card is low. Replace the SD card.
appears in red on the screen.
- An SD card error occurred. Remove and reinsert the SD card. If the display does not change back to normal, save your
MP4 clips (
A
168) and photos and initialize the SD card (
A
41).
Even after stopping recording, the CF card access indicator or SD card access indicator stays illuminated in red.
- The clip is being recorded. This is not a malfunction.
7
keeps flashing on the screen.
- You connected the optional GP-E2 GPS Receiver to the camcorder’s USB terminal in mode. Disconnect the
GP-E2 and connect in again after setting the camcorder in mode.
U
keeps flashing on the screen.
- The camcorder cannot lock on the external Genlock signal being input. Check the external signal. If necessary, check
the [TC/UB Setup]
>
[XF Legacy Sync] setting (
A
204).
Picture and Sound
The OLED screen is too dark.
- Adjust the brightness with the [OLED/VF Setup]
>
[OLED Setup]
>
[Brightness] setting. To make the screen brighter
temporarily, set [OLED/VF Setup]
>
[OLED Setup]
>
[Luminence] to [On].
Screen displays turn on and off repeatedly.
- The battery pack is exhausted. Replace or charge the battery pack.
- Remove the battery pack and reattach it correctly.
COP
Y