Canon RC-IP1000, Руководство пользователя

Страница: 17 / 94

17
Terminals Area
45
EXHAUST VENT
46
POWER Switch
Turns the device on/off.
47
DC IN 12V
Terminal (P. 23)
Power terminal for use with an external DC power
supply.
48
GND Terminal
The device’s ground terminal.
49
LAN
Terminal
Terminal used for network connection (RJ-45
connector). You can connect it to a hub
compatible with PoE+ (Power over E) to
supply power to the device (P. 24).
Use a LAN cable of category 5e or higher. When
supplying power via PoE+, use an STP cable. The
use of STP cables is recommended even if PoE+
power supply is not used.
50
RS-422 1 / 2 / 3 / 4 / 5 Terminals (P. 88)
Serial terminal with RS-422 support (RJ-45
connector). Use of category 5e or higher STP
cables is recommended.
51
USB
Terminal (Rear)
You can connect a USB memory to the terminal.
You can use a USB memory formatted with FAT32
or exFAT.
52
HDMI OUT
Terminal
Terminal for HDMI output.
53
SDI OUT Terminal
Terminal for SDI output.
54
SDI IN
Terminal
Terminal for SDI input.
55
GPIO 1 Terminal, GPIO 2 Terminal (P. 85)
You can connect to an external device to send and
receive tally information, CAMERA / PRESET
selection information and GROUP selection
information. Use shielded cables for connection
with this terminal.
56
AIR INTAKE
/ Intake Fan
45
47
46
48 49 50 51 53 54 55 56 52
Important
While the cooling fan is running, warm air is discharged
through the EXHAUST VENT. Do not block the
EXHAUST VENT using tape or other objects.
Important
Do not connect a PoE power supply LAN cable to the
RS-422 terminals. This may cause malfunctions.
Important
Do not block the AIR INTAKE using tape or other
objects.