Canon EOS C100 Mark II, Инструкция по эксплуатации

Страница: 83 / 214

83
Setting the User Bit
Setting the User Bit
The user bit display can be selected from the date or the time of
recording, or an identification code consisting of 8 characters in the
hexadecimal system. There are sixteen possible characters: the numbers
0 to 9 and the letters A to F. The camcorder can embed the user bit in
your AVCHD clips and output it from the HDMI OUT terminal.
* The user bit cannot be embedded in MP4 clips.
1 Open the user bit [Type] submenu.
[
¤
TC/UB Setup]
>
[User Bit]
>
[Type]
2 Select the desired user bit type and then press the joystick.
• Select [Setting] to set your own identification code, [Time] to use the time as user bit, or [Date] to use the
date as the user bit.
• If you selected [Time] or [Date], you do not need to perform the rest of the procedure. If you selected
[Setting], continue the procedure to set the identification code.
3 Select [Set] and then press the joystick.
• The user bit setting screen appears with an orange selection frame on the leftmost digit.
• To reset the user bit to [00 00 00 00], select [Reset] instead.
4 Push the joystick up/down to select the first character and then press the joystick to move to the
next digit.
• Change the rest of the digits in the same way.
• Press the CANCEL button to close the screen without setting the user bit.
5 Select [Set] and then press the joystick to close the screen.
NOTES
• User bit output : In mode, when the frame rate is set to 23.98P, you can output the user bit as 2:3
pulldown data by setting [
¤
TC/UB Setup]
>
[User Bit]
>
[Output Mode] to [Pulldown].
Operating modes:
*
[
¤
TC/UB Setup]
[User Bit]
[Type]
[Setting]
COP
Y