Canon 6160, Руководство по эксплуатации

Страница: 177 / 222

Lubricate the die sets - Lubricate the punch pins
Introduction
The die sets have a life expectancy of approximately 500,000 punched sheets. However, when
you lubricate the die sets on a regular basis, the life expectancy can increase. You must regularly
lubricate the following parts.
• The punch pins.
• The shoulder bolts and springs.
• The felt oil pad, if applicable.
Some die sets have a felt oil pad that must be lubricated. The following table indicates which
types of die set do or do not have a felt oil pad.
Types of die sets with and without a felt pad
Type Description Die sets
1 No felt oil pad
2-, 3-, 4-Hole and VeloBind
®
2 A felt oil pad on 1 side, including a
magnet and retaining plate 02:01 AM and 03:01 AM Wire (round
and square holes)
3 A felt oil pad surrounds the punch
pins 19-, 20-, 21-Hole comb
44-, 47-Hole coil
When to do
• Lubricate the punch pins every 50,000 punched sheets.
• Lubricate the shoulder bolts and springs every 200,000 punched sheets.
Required tools
Use a high quality machine oil to lubricate the die sets.
IMPORTANT
Do not use an aerosol (spray) type of oil. This type of oil leaves a sticky residue on the pins and
attracts paper dust.
NOTE
See
Replace a die set on page 175
for information about how to remove and insert a die set into
the die set slot.
Illustration
1
2
3
[55] Lubrication points
Lubricate the die sets - Lubricate the punch pins
Chapter 10 - Optional finishers and other devices 177