Brother 882-W70, Руководство по эксплуатации, Страница: 42 / 212

WINDING/INSTALLING THE BOBBIN
40
Setting the Bobbin
a
Press to lock all keys and buttons and raise the
presser foot.
* If the message [OK to automatically lower the
presser foot?] appears on the LCD screen, press
to continue.
b
Slide the bobbin cover latch to the right and remove
the bobbin cover.
c
Insert the bobbin into the bobbin case so that the
thread unwinds to the left.
d
Lightly hold down the bobbin with your right hand
(
1
), and then guide the end of the thread around the
tab of the needle plate cover with your left hand ( 2 ).
e
While lightly holding down the bobbin with your right
hand (
1
), guide the thread through the slit in the
needle plate cover (
2
) and lightly pull it with your left
hand (
3
).
f
While lightly holding down the bobbin with your right
hand (
1
), continue guiding the thread through the slit
with your left hand (
2
). Then, cut the thread with the
cutter (
3
).
CAUTION
• Use a bobbin that has been correctly wound
with thread, otherwise the needle may break
or the thread tension will be incorrect.
• Before inserting or changing the bobbin, be
sure to press in the LCD to lock all keys
and buttons. Otherwise injuries may occur if
the “Start/Stop” button or any other button is
pressed and the machine starts sewing.
1
Tab
CAUTION
• Be sure to hold down the bobbin with your
finger and unwind the bobbin thread
correctly, otherwise the thread may break or
the thread tension will be incorrect.
Memo
• By guiding the thread around the tab of the needle
plate cover, passing the thread as shown by
2
in
this illustration, then lightly pulling the thread at
3
,
the thread will enter the tension spring of the
bobbin case to apply the appropriate tension to the
bobbin thread during sewing.
Memo
• Be sure to complete the bobbin threading correctly
according to these instructions. If the thread is
simply placed in the slit in the needle plate cover,
the bobbin thread will not be correctly threaded,
resulting in poor sewing performance or incorrect
thread tension.