Balancer Cube
Operator's manual
6
GB
2.1 Temporary d
i
sabling of the diameter and distance sensor
(where applicable)
If the machine displays the error code
Err 016 “dis out”
(distance/diameter sensor not in the rest
position) at start-up, although being in rest position, it means that an anomaly has occurred in the acqui-
sition system.
However, i
t is possible to immediately (and temporarily) disable the acquisition system by pressing the
button
[F + P2]
. The LED [6],
located on the control panel, will light up to indicate that
the automatic acquisition system is disabled and that the machine is ready for use.
If you are not
able to use the automatic acquisition system, sizes of the wheel must be entered
manually as described in chapters 3.3.1 and 3.3.2. By switching the machine off and then on, the error
code will be displayed again for which it will be necessary to repeat the procedure described above.
3. USE OF THE MACHINE
To use the machine, you must select or set as follows:
• Program type (program for wheels with steel, aluminium or special aluminium rims).
Default = program for wheels with steel rims;
• Wheel Type (auto-vehicle, motorbike, off-road). Default = auto-vehicle;
• Dimensions of the wheel to balance. The dimensions can be entered manually (always) or partially or fully
in automatic (only available on some models).
• Dynamic or Static balancing. Default = Dynamic;
• Display resolution X1 or X5. Default = X5;
The selections described above may be entered before or after the
spin
. For any variation of the selection or
data settings, the machine will run a recalculation by displaying the new values of imbalance.
Once the selections/settings have been entered, you can run a
balance
by rotating manually the wheel in
clokwise direction until you hear a beep.
At the end of the
balancing
, the machine displays the wheel imbalance values.
Apply the weights displayed by the machine at the indicated positions and
balance
once
again
. Normally,
the weights should be applied at the 12 o’clock position with the exception of special program
s
for ALS2 and
ALS1 aluminium.
+
Содержание OSPREY BP63
Страница 1: ...BP63 OSPREY...
