Balancer Cube
Operator's manual
10
GB
MOTO
Motorbikes
Forcibly set the ALU1 Program
Type
SUV
Off-Road vehicles
Not suitable for balancing wheels
of trucks
Each of these programs set specific values for the measurement of the dimensions of the wheel and the
calculation of imbalances. The particularities of each program are indicated in the following paragraphs.
To select a specific Wheel Type, press repeatedly [P6]
until the corresponding LED turns on as
shown in the table T3.2.
3.2.1 CAR wheel type (auto-vehicles)
The selection of the CAR Wheel Type
provides wheel balancing for
auto-vehicles. For off-road vehicles, it
may be appropriate to select the SUV Wheel Type (see paragraph below).
To select the CAR wheel type, press repeatedly [P6]
until the CAR LED of the Wheel Type group
LED lights up. See table T3.2.
3.2.2 MOTO wheel type (motorbikes)
The selection of the MOTO Wheel Type
provides wheel balancing for
motorbikes.
These wheels need to be mounted on the shaft of a special flange. Since the flange pushes the wheel away
from the machine, you must also install a special extension for the distance sensor.
To select the MOTO wheel type, press repeatedly [P6]
until the MOTO LED of the Wheel Type
group LED lights up. See table T3.2.
When the MOTO wheel type is enabled, the ALU1 Program
Type is automatically selected and any attempt
to select another type by pressing [P4]
or [P5]
will be rejected. The point of
application of the weights along the rim section is that of the ALU1 Program Type and is indicated in
figure F3.1.When the MOTO Wheel Type is enabled, you can select the display of dynamic or static
imbalance by pres-
sing [F+P2]
but if the set width of the wheel is less than 114 mm (or 4.5 inches), the
static imbalance value will be always displayed.
To acquire the geometric data of the wheel automatically with the Distance/Diameter and Width
sensors, you must use the same reference points on the rim of the ALU1 Program Type.
Furthermore, when the MOTO wheel type is enabled, the current distance value is automatically increased
by 150 mm in order to take account of the length of the extension for the Distance sensor.
+
Содержание OSPREY BP63
Страница 1: ...BP63 OSPREY...
