Balancer Cube
Operator's manual
30
GB
Note:
This program can be used with any Program Type and with any Wheel Type. It can also be used to divide the
static weight into two separate weights (especially useful with wheels for motorbikes).
To use this program, proceed as follows:
1. Perform the balancing of the wheel without applying the external weight;
2. Press [F+P5]
to run the Hidden Weights program. If the wheel is balanced on
the external side, the machine will display the message shown in figure F 6.2 for about 1 second on
the right display and a triple beep will indicate that the operation is not allowed.
Fig. F
6
.2 Hidden Weight Program not possible or chosen position not allowed
3. If there is an imbalance on the external side instead, the machine will display the message shown in
the figure. F6.3.
Fig.
F6.3
Input
of
the
weight
W1
position
Note:
You can exit the “hidden weights” program
at any time by pressing [F+P5]
.
4. Rotate the wheel manually until all external imbalance search LEDs light up (see detail [9] of figure
F10).
5. Rotate the wheel manually until the point where you want to apply the external weight W1 is reached
and press [P1]
to confirm. The angle formed by W1 and by the initial external weight W must
be less than 120°.
6. If the angle is greater than 120°, the machine will display the message shown in figure F6.2 for one
second and will emit a triple beep indicating that another point must be chosen. If the angle instead
is less than 120°, the machine will display the message shown in Fig. F6.4, allowing you to continue
with the next step.
+
+
Содержание OSPREY BP63
Страница 1: ...BP63 OSPREY...
