27
Balancer Cube
Operator’s manual
5. OPTIMISATION
The optimisation program is used to minimise the amount of balancing weights to be applied on the
rim by opposing the imbalance of the rim to that of the t
i
re.
Therefore, use this program when the wheel requires the application of heavy balancing weights.
To
access the optimisation program proceed as follows:
1. Press [F+P4]
. The display will show the options shown in figure F5.1. Press [P4]
or [P5]
and choose the option
oPt-1-
to continue, or the option
oPt rEt
to
return to the operating program. Press [F+P4]
to confirm the chosen option;
Fig. F5.1 Access to the Optimisation program
Note:
you can exit the calibration procedure at any time by repeatedly pressing [F+P4]
.
2. If the wheel’s static imbalance is less than 12 grams, the machine will display the message shown in
Figure F5.2 for a second and then will automatically exit the optimisation program. If the wheel’s
static imbalance is instead greater than or equal to 12 grams, the message shown in Figure F5.3 will
be displayed;
Fig. F5.2 Optimisation Program not possible
+
+
+
Содержание OSPREY BP63
Страница 1: ...BP63 OSPREY...
