BRIGHT OSPREY BP63, Руководство оператора

Страница: 24 / 44

23 Balancer Cube Operator’s manual
To run the machine calibration, proceed as follows:
1. Start-up the machine;
2. Remove the wheel and any other accessories from the shaft;
3. Press [F+P3]. The writing
SER SER
will be displayed (this means that we have entered the
SERVICE mode) (service program);
4. Press [P3] . The writing CAL CAR (machine calibration for auto-vehicle and light off-road
vehicle wheels);
5. With buttons [P4] or [P5] , select the CAR (auto-vehicle and light off-road wheels)
or MOT (motorbike wheels) calibration type.
Note:
T he calibration for motorbike wheels is described separately in chapter 4.3 Machine calibration for MOTO Wheel
Type.
. The writing
CAL 0
will be displayed; 6. Press [P3]
7. Now , you can run a balance by manually rotate the wheel in clo c kwise direction until you
hear a beep.
The machine will start and will show thewriting CAL 1 on the display
once completed .
Start or lower the wheel guard.
8. Mount the wheel on the shaft and enter its dimensions by pressing the keys [P1] , [P2]
, [P3] to select the dimensions to edit and keys [P4] or [P5] to edit
the value. If the dimensions of the wheel were introduced before entering the calibration program,
this step can be skipped. It is not possible to enter the data with the automatic acquisition system;
9. Run a balance by rotating manually the wheel in clokwise direction until you hear a beep.
10. Once the launch is completed, manually rotate the wheel until value 50 is seen on the left
display. Apply the 50 g weight at the 12 o’clock position on the internal side of the wheel.
11. Run a balance by manually rotating the wheel in clokwise direction until you hear a beep.
12. Remove the 50 g weight applied on the internal side.
13. Manually rotate the wheel until the value 50 is seen on the right display. Apply the 50 g weight
at the 12 o’clock position on the external side of the wheel.
14. Run a balance by manually rotating the wheel in clo c kwise direction until you hear a beep.
15. The machine switches directly to the next step